Gigabyte GA-H97M-Gaming 3 - Miscellaneous Settings

- 23 -
& Fan Speed Percentage
Allows you to control the fan speed. This item is congurable only when 1st System Fan Speed Control
is set to Manual. Options are: 0.75 PWM value /
o
C ~ 2.50 PWM value /
o
C.
& 2nd System Fan Speed Control (SYS_FAN2 Connector)
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Normal Allows the fan to run at different speeds according to the system temperature. You can
adjust the fan speed with EasyTune based on your system requirements. (Default)
Silent Allows the fan to run at slow speeds.
Manual Allows you to control the fan speed under the Fan Speed Percentage item.
Full Speed Allows the fan to run at full speeds.
& Fan Speed Percentage
Allows you to control the fan speed. This item is congurable only when 2nd System Fan Speed Control
is set to Manual. Options are: 0.75 PWM value /
o
C ~ 2.50 PWM value /
o
C.
& 3rd System Fan Speed Control (SYS_FAN3 Connector)
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Normal Allows the fan to run at different speeds according to the system temperature. You can
adjust the fan speed with EasyTune based on your system requirements. (Default)
Silent Allows the fan to run at slow speeds.
Manual Allows you to control the fan speed under the Fan Speed Percentage item.
Full Speed Allows the fan to run at full speeds.
& Fan Speed Percentage
Allows you to control the fan speed. This item is congurable only when 3rd System Fan Speed Control
is set to Manual. Options are: 0.75 PWM value /
o
C ~ 2.50 PWM value /
o
C.
` Miscellaneous Settings
& PCIeSlotConguration
Allows you to set the operation mode of the PCI Express slots to Gen 1, Gen 2, or Gen 3. Actual operation
mode is subject to the hardware specication of each slot. Auto lets the BIOS automatically congure this
setting. (Default: Auto)
& DMI Gen2 Speed
Allows you to congure the DMI link speed.
Auto Lets the BIOS automatically congure this setting.
Enabled Sets the DMI link speed to Gen 2. (Default)
Disabled Sets the DMI link speed to Gen 1.
& 3DMark01 Boost
Allows you to determine whether to enhance some legacy benchmark performance. (Default: Disabled)