Gigabyte GA-J1800M-D2P - Page 20

- 20 -
` PPMConguration
& CPU C state Report
Enables or disables support for CPU's power-saving functions. (Default: Enabled)
& Enhanced C state
Enables or disables Intel
®
CPU Enhanced Halt (C1E) function, a CPU power-saving function in system
halt state. When enabled, the CPU core frequency and voltage will be reduced during system halt state
to decrease power consumption. This item is congurable only when CPU C state Report is enabled.
(Default: Enabled)
& Max CPU C-state
Allows you to determine the maximum C state that the CPU will support. Options include: C6, C1 (default).
This item is congurable only when CPU C state Report is enabled.
` ThermalConguration
& DTS
Enables or disables the CPU overheating protection function. (Default: Disabled)
& Critical Trip Point
Allows you to set the CPU temperature threshold. If the CPU temperature reaches this value, the operating
system will shut down the system. This item is congurable only when DTS is enabled. (Default: 100 C)
& Passive Trip Point
Allows you to set the CPU temperature threshold. If the CPU temperature reaches this value, the CPU frequency
will be automatically reduced. This item is congurable only when DTS is enabled. (Default: 85 C)
` IDEConguration
& Serial-ATA (SATA)
Enables or disables the integrated SATA controllers. (Default: Enabled)
& SATA Mode
Allows you to decide whether to congure the SATA controller integrated in the Chipset to AHCI mode. This
item is congurable only when Serial-ATA(SATA) is set to Enabled.
IDE Mode Disables RAID for the SATA controllers and congures the SATA controllers to IDE
mode.
AHCI Mode Congures the SATA controllers to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specication that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug. (Default)
& Serial-ATA Port 0/Serial-ATA Port 1
Enables or disables each SATA port. This item is congurable only when Serial-ATA(SATA) is set to
Enabled. (Default: Enabled)
& SATA Port0/SATA Port1 HotPlug
Enables or disable the hot plug capability for each SATA port. This item is congurable only when Serial-
ATA(SATA) is set to Enabled. (Default: Disabled)
The area below displays the current status of each SATA port.
` NetworkStackConguration
& Network stack
Disables or enables booting from the network to install a GPT format OS, such as installing the OS from
the Windows Deployment Services server. (Default: Disabled)
& Ipv4 PXE Support
Enables or disables IPv4 PXE Support. This item is congurable only when Network stack is enabled.