- 4 -GA-K8N Pro Motherboard
English
When you installing AGP card, please make sure the following notice is fully understood and
practiced. If your AGP card has "AGP 4X/8X(1.5V) notch" (show below), please make sure your
AGP card is AGP 4X/8X(1.5V).
AGP 2X(3.3V) card is not supported by nVIDIA
®
nForce
™
3 150 chipset. You might experience
system unable to boot up normally. Please insert an AGP 4X/8X(1.5V) card.
Although Gigabyte's AG32S(G) graphics card is based on ATi Rage 128 Pro chip, the design of
AG32S(G) is compliance with AGP 4X(1.5V) specification. Therefore, AG32S(G) will work fine
with nVIDIA
®
nForce
™
3 150 based motherboards.
Before you install PCI cards, please remove the Dual BIOS label from PCI slots if there is one.
Read Me First !
AGP 4X/8X notch
K8n pro_1001_i.p65 2003/8/18, ¤U¤È 06:034
To Next Page
Loading...