Gigabyte GA-K8RS482M-FS-02 - 2-4 Power Management Setup

GA-K8RS482M-FS-02 Motherboard - 24 -
English
2-4 Power Management Setup
Modem Ring Resume
An incoming call via modem can awake the system from any suspend state or an input signal
ocmes from the other client server on the LAN can awake the system from any suspend state.
Disabled Disable ModemRingOn WakeOnLan function.(Default value)
Enabled Enable ModemRingOn WakeOnLan function.
ACPI Suspend Type
S1(POS) Set ACPI suspend type to S1/POS(Power On Suspend).
S3(STR) Set ACPI suspend type to S3/STR(Suspend To RAM). (Default value)
Power LED in S1 state
Blinking The Power LED will be blinking during S1 state.(Default value)
dual/OFF The Power LED will be turned off or change color.
Soft-off by PWR-BTTN
Instant-off Press power button then Power off instantly. (Default value)
Delay 4 Sec. Press power button 4 sec. to Power off. Enter suspend if button is pressed
less than 4 sec.
AC BACK Function
Soft-Off When AC-power is back to the system, the system will be in "Soft-Off" state.
Full-On When AC-power is back to the system, the system will be always in "Full-On"
state.
Memory When AC-power is back to the system, the system will return to the last state
before AC-power was off.(Default value)
RTC Alarm Resume
You can set "Resume by Alarm" item to enabled and key in Data/time to power on system.
Disabled Disable this function. (Default value)
Enabled Enable alarm function to POWER ON system.
If RTC Alarm Lead To Power On is Enabled.
Date (of Month) Alarm : Everyday, 1~31
Time (hh: mm: ss) Alarm : (0~23) : (0~59) : (0~59)
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Power Management Setup
Modem Ring Resume [Disabled]
ACPI Suspend Type [S3(STR)]
Power LED in S1 state [Blinking]
Soft-Off by PWR-BTTN [Instant-Off]
PowerOn by PCI Card [Disabled]
AC BACK Function [Memory]
RTC Alarm Resume [Disabled]
x Date (of Month) Alarm Everyday
x Time (hh:mm:ss) Alarm 0 : 0 : 0
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F7: Default Setting
Item Help
Menu Level`