Gigabyte GA-M56S-S3 - Page 40

GA-M56S-S3 Motherboard - 40 -
English
NV SATA Pri-Master RAID
Enables or disables RAID for the first SATA 3Gb/s connector (SATAII0). This item is configurable
only if the Onchip SATA Mode item is set to RAID. (Default: Enabled)
NV SATA Pri-Slave RAID
Enables or disables RAID for the second SATA 3Gb/s connector (SATAII1). This item is configurable
only if the Onchip SATA Mode item is set to RAID. (Default: Enabled)
NV SATA Sec-Master RAID
Enables or disables RAID for the third SATA 3Gb/s connector (SATAII2). This item is configurable
only if the Onchip SATA Mode item is set to RAID. (Default: Enabled)
NV SATA Sec-Slave RAID
Enables or disables RAID for the fourth SATA 3Gb/s connector (SATAII3). This item is configurable
only if the Onchip SATA Mode item is set to RAID. (Default: Enabled)
On-Chip IDE Channel0
Enables or disables the first integrated IDE controller. (Default: Enabled)
IDE DMA transfer access
Enables or disables DMA (Direct Memory Access) mode for the IDE device(s). Disabled turns off
DMA mode for the IDE device(s) and lets it operate in PIO (Programmed Input/Output) mode.
(Default: Enabled)
On-Chip MAC LAN
Enables or disables the onboard LAN function. (Default: Auto)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item
to Disabled.
NV Serial-ATA 1
Enables or disables the integrated SATA controllers. (Default: Enabled)
IDE Prefetch Mode
Enables or disbales prefetch mode for the integrated IDE controller. Enabled activates the IDE
prefetch buffer to enhance hard drive performance. (Default: Enabled)
Serial-ATA RAID Config
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
Serial-ATA RAID Config
Item Help
Menu Level`
x NV SATA Pri-Master RAID Enabled
x NV SATA Pri-Slave RAID Enabled
x NV SATA Sec-Master RAID Enabled
x NV SATA Sec-Slave RAID Enabled
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults