Hardware Installation- 25 -
9) SATAII0/1/2/3/4/5 (SATA 3Gb/s Connectors)
The SATA connectors conform to SA TA 3Gb/s standard and are compatible with SA TA 1.5Gb/s
standard. Each SATA connector supports a single SA TA device. The AMD SB700 controller
supports RAID 0, RAID 1 and RAID 10. Refer to Chapter 5, "Configuring SA TA Hard Drive(s)," for
instructions on configuring a RAID array.
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
• A RAID 10 configuration requires at least four hard drives and the total number of hard
drives must be an even number.
10) PWR_LED (System Power LED Header)
This header can be used to connect a system power LED on the chassis to indicate system power
status. The LED is on when the system is operating. The LED keeps blinking when the system is
in S1 sleep state. The LED is off when the system is in S3/S4 sleep state or powered off (S5).
Pin No. Definition
1 MPD+
2 MPD-
3 MPD-
System Status LED
S0 On
S1 Blinking
S3/S4/S5 Off
Please connect the L-shaped end
of the SATA 3Gb/s cable to your
SATA hard drive.
1
17
1
7
SATAII1
SATAII0
17
1
7
SATAII3
SATAII2
17
1
7
SATAII5
SATAII4
To Next Page
Loading...
