Gigabyte GA-MA790FX-DQ6 - Page 84

GA-MA790FX-DQ6 Motherboard - 84 -
English
The BIOS Setup menus described in this section may differ from the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
Step 2:
Save changes and exit BIOS Setup.
For example, if you wish to create RAID with hard drives on the GSATAII_1 and GSATAII_2 connectors,
ensure that Onboard GSATA-II Ctrl2 is enabled. Set Onboard GSATA-II Ctrl2 Mode to RAID (Figure
2). If you do not want to create RAID, set this item to IDE or AHCI, depending on your need.
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
OnBoard PCIE Device
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level`
Onboard LAN1 Function [Enabled]
Onboard LAN1 Boot ROM [Disabled]
` SMART LAN1 [Press Enter]
Onboard LAN2 Function [Enabled]
Onboard LAN2 Boot ROM [Disabled]
` SMART LAN2 [Press Enter]
Onboard ESATA-II Ctrl1 [Enabled]
Onboard ESATA-II Ctrl1 Mode [IDE]
Onboard GSATA-II Ctrl2 [Enabled]
Onboard GSATA-II Ctrl2 Mode [RAID]
Figure 2
For example, if you wish to create RAID with hard drives on the eSATA 3Gb/s ports, ensure that
Onboard ESATA-II Ctrl1 is enabled. Set Onboard ESATA-II Ctrl1 Mode to RAID (Figure 2). If you
do not want to create RAID, set this item to IDE or AHCI, depending on your need.
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
OnBoard PCIE Device
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level`
Onboard LAN1 Function [Enabled]
Onboard LAN1 Boot ROM [Disabled]
` SMART LAN1 [Press Enter]
Onboard LAN2 Function [Enabled]
Onboard LAN2 Boot ROM [Disabled]
` SMART LAN2 [Press Enter]
Onboard ESATA-II Ctrl1 [Enabled]
Onboard ESATA-II Ctrl1 Mode [RAID]
Onboard GSATA-II Ctrl2 [Enabled]
Onboard GSATA-II Ctrl2 Mode [IDE]
Figure 2