Gigabyte GA-P55-UD5 - Page 58

BIOS Setup - 58 -
eSATA Ctrl Mode (JMB362 Chip, eSATA Connectors on the Back Panel)
Enables or disables RAID for the SATA controller integrated in the JMB362 chip or congures the SATA
controller to AHCI mode.
IDE Disables RAID for the SATA controller and congures the SATA controller to IDE
mode. (Default)
AHCI Congures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specication that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
RAID Enables RAID for the SATA controller.
GSATA 0_1/IDE Controller (GIGABYTE SATA2 Chip, IDE and GSATA2_0/1 Connectors)
Enables or disables the IDE and SATA controller integrated in the GIGABYTE SATA2 chip. (Default: En-
abled)
GSATA 0_1/IDE Ctrl Mode (GIGABYTE SATA2 Chip, IDE and GSATA2_0/1 Connectors)
Enables or disables RAID for the SATA controller integrated in the GIGABYTE SATA2 chip or congures
the SATA controller to AHCI mode.
IDE Congures the SATA controller to IDE mode. (Default)
AHCI Congures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specication that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
RAID/IDE Enables RAID for the SATA controller; the IDE controller still operates in IDE mode.
GSATA 2_3 Controller (JMB362 Chip, GSATA2_2/3 Connectors)
Enables or disables the SATA controller integrated in the JMB362 chip. (Default: Enabled)
GSATA 2_3 Ctrl Mode (JMB362 Chip, GSATA2_2/3 Connectors)
Enables or disables RAID for the SATA controller integrated in the JMB362 chip or congures the SATA
controller to AHCI mode.
IDE Congures the SATA controller to IDE mode. (Default)
AHCI Congures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specication that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
RAID Enables RAID for the SATA controller.
Onboard Serial Port 1
Enables or disables the rst serial port and species its base I/O address and corresponding interrupt.
Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.