Gigabyte GA-P61-USB3-B3 - Page 24

Hardware Installation - 24 -
7) SATA2_0/1/2/3 (SATA 3Gb/s Connectors, Controlled by H61 Chipset)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device.
ARAID0orRAID1congurationrequirestwoharddrives.
8) GSATA3_4/5 (SATA 6Gb/s Connectors, Controlled by Marvell 88SE9172 chip)
j
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Marvell 88SE9172 chip
supportsRAID0andRAID1.RefertoChapter5,"ConguringSATAHardDrive(s),"forinstructionson
conguringaRAIDarray.
Please connect the L-shaped end of
the SATA cable to your SATA hard
drive.
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
SATA2_0SATA2_2
SATA2_1SATA2_3
7
1
7
1
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
GSATA3_4
GSATA3_5
7
1
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
j
Only for GA-PA65-D3-B3.