Gigabyte GA-P61-USB3-B3 - Page 47

- 47 - BIOS Setup
GSATA3 Controller (Marvell 88SE9172 Chip, GSATA3_4 and GSATA3_5 connectors)
j
Enables or disables the SATA controller integrated in the Marvell 88SE9172 chip. (Default: Enabled)
GSATA3 Ctrl Mode (Marvell 88SE9172 Chip, GSATA3_4 and GSATA3_5 connectors)
j
 EnablesordisablesRAIDfortheSATAcontrollerintegratedintheMarvell88SE9172chiporcongures
the SATA controller to AHCI mode.
IDE  CongurestheSATAcontrollertoIDEmode.(Default)
AHCI  CongurestheSATAcontrollertoAHCImode.AdvancedHostControllerInterface(AHCI)
isaninterfacespecicationthatallowsthestoragedrivertoenableadvancedSerialATA
features such as Native Command Queuing and hot plug.
RAID Enables RAID for the SATA controllers.
Onboard Serial Port 1
 EnablesordisablestheserialportandspeciesitsbaseI/Oaddressandcorrespondinginterrupt.
Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.
Onboard Parallel Port
 Enablesordisablestheonboardparallelport(LPT)andspeciesitsbaseI/Oaddressandcorrespond-
ing interrupt. Options are: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
Selects an operating mode for the onboard parallel (LPT) port. Options are: SPP (Standard Parallel Port)
(default), EPP (Enhanced Parallel Port), ECP (Extended Capabilities Port), ECP+EPP.
j
Only for GA-PA65-D3-B3.