Gigabyte GA-P67A-D3-B3 - Page 24

Hardware Installation - 24 -
A RAID 0 or RAID 1 conguration requiresat least two harddrives. If more than twohard
•
drives are to be used, the total number of hard drives must be an even number.
ARAID5congurationrequiresatleastthreeharddrives.(Thetotalnumberofharddrives
•
does not have to be an even number.)
ARAID10congurationrequiresfourharddrives.
•
7) SATA3 0/1 (SATA 6Gb/s Connectors, Controlled by Intel P67 Chipset)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The "SATA3 0" and "SATA3
1" connectors support RAID 0 and RAID 1. RAID 5 and RAID 10 can be implemented on the two con-
nectors with the "SATA2 2/3/4/5" connectors
(Note)
.RefertoChapter5,"ConguringSATAHardDrive(s),"
forinstructionsonconguringaRAIDarray.
Please connect the L-shaped end of the
SATA cable to your SATA hard drive.
8) SATA2 2/3/4/5 (SATA 3Gb/s Connectors, Controlled by Intel P67 Chipset)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device. The Intel P67 Chipset supports RAID 0, RAID
1, RAID 5, and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on
conguringaRAIDarray.
(Note) When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system perfor-
mance of the RAID set may vary depending on the devices being connected.
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
1
1
DEBUG
PORT
G.QBOFM
7
7
71
71
DEBUG PORT
G.QBOFM
DEBUG PORT
G.QBOFM
DEBUG PORT
G.QBOFM
DEBUG PORT
G.QBOFM
4 2
5 3
1
0
SATA3
SATA2