Gigabyte GA-P67A-UD5 - Page 51

- 51 - BIOS Setup
Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
Onboard USB3.0 Controller (Renesas D720200 USB 3.0 Controller)
Enables or disables the Renesas D720200 USB 3.0 controller. (Default: Enabled)
USB3.0 Turbo (Renesas D720200 USB 3.0 Controller)
Enables or disables the Turbo USB mode for the Renesas D720200 USB 3.0 controller. The actual per-
formance may vary depending on the number of devices being installed. (Default: Disabled)
eSATA3 Controller (Marvell 88SE9128 Chip, eSATA3 Connectors on the Back Panel)
Enables or disables the SATA controller integrated in the Marvell 88SE9128 chip. (Default: Enabled)
eSATA3 Ctrl Mode (Marvell 88SE9128 Chip, eSATA3 Connectors on the Back Panel)
 AllowsyoutodecidewhethertoconguretheSATAcontrollerintegratedintheMarvell88SE9128chip
to AHCI mode.
IDE   CongurestheSATAcontrollertoIDEmode.(Default)
AHCI   Congures theSATA controller toAHCI mode.Advanced Host Controller Interface
(AHCI)isaninterfacespecicationthatallowsthestoragedrivertoenableadvanced
Serial ATA features such as Native Command Queuing and hot plug.
SATA3 Firmware Selection
 DetermineswhethertoautomaticallyupdatethermwareoftheMarvell88SE9128chip.
Onchip  Keepstheoriginalrmwareversion.
Auto   LetstheBIOSautomaticallyupdatethermwaretothelatestversion.(Default)
eSATA3 RAID Conguration (Marvell 88SE9128 Chip, eSATA3 Connectors on the Back
Panel)
 AllowsyoutocongureRAIDfortheMarvell88SE9128SATAcontroller.RefertoChapter5,"Congur-
ingSATAHardDrive(s),"forinstructionsonconguringaRAIDarray.
When a Cable Problem Occurs...
 Ifacableproblemoccursonaspeciedpairofwires,theStatuseldwillshowShort and then length
shown will be the approximate distance to the fault or short.
Example:
Part1-2 Status = Short / Length = 2m
Explanation: A fault or short might occur at about 2m on Part 1-2.
Note: Part 4-5 and Part 7-8 are not used in a 10/100 Mbps environment, so their Statuseldswillshow
Open, and the length shown is the approximate length of the attached LAN cable.