EasyManua.ls Logo

Gigabyte GA-P75-D3 - Page 47

Gigabyte GA-P75-D3
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 47 - BIOS Setup
Audio Controller &
Enables or disables the onboard audio function. (Default: Enabled)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to
Disabled.
Init Display First &
Species the rst initiation of the monitor display from the installed PCI graphics card or the PCI Express
graphics card.
Auto Lets BIOS automatically congure this setting. (Default)
PEG Sets the PCI Express graphics card on the PCIEX16 slot as the rst display.
PCI Sets the graphics card on the PCI slot as the rst display.
Intel(R) Rapid Start Technology &
Enables or disables Intel Rapid Start Technology. This item is congurable only when an SSD is installed.
(Default: Disabled)
Legacy USB Support &
Allows USB keyboard/mouse to be used in MS-DOS. (Default: Enabled)
USB3.0 Support &
Enables or disables the integrated USB 3.0 controller. (Default: Enabled)
XHCI Hand-off &
Determines whether to enable XHCI Hand-off feature for an operating system without XHCI Hand-off
support. (Default: Enabled)
EHCI Hand-off &
Determines whether to enable EHCI Hand-off feature for an operating system without EHCI Hand-off
support. (Default: Disabled)
Port 60/64 Emulation &
Enables or disables emulation of I/O ports 64h and 60h. This should be enabled for full legacy support
for USB keyboards/mice in MS-DOS or in operating system that does not natively support USB
devices. (Default: Disabled)
USB Storage Devices &
Displays a list of connected USB mass storage devices. You can congure how each device is going to
be treated. For example, you can emulate a USB ash drive as a oppy disk drive. (Default: Auto)
Trusted Computing `
TPM SUPPORT &
Enables or disables Trusted Platform Module (TPM). Set this item to Enabled when a TPM device is
installed. (Default: Disabled)
OnBoard LAN Controller#1 &
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.

Table of Contents

Related product manuals