Gigabyte GA-Q170M-D3H - Page 7

Storage Interface  Chipset:
- 1 x M.2 connector (Socket 3, M key, type 2242/2260/2280 SATA and
PCIe x4/x2/x1 SSD support)
- 3 x SATA Express connectors
- 6 x SATA 6Gb/s connectors
 - SupportforRAID0,RAID1,RAID5,andRAID10
* Referto"1-7InternalConnectors,"forthesupportedcongurationswiththeM.2,
SATA Express, and SATA connectors.
USB  Chipset:
- 8 x USB 3.0/2.0 ports (4 ports on the back panel, 4 ports available through
the internal USB headers)
- 6 x USB 2.0/1.1 ports (2 ports on the back panel, 4 ports available through
the internal USB headers)
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 4-pin ATX 12V power connector
 1 x M.2 Socket 3 connector
 3 x SATA Express connectors
 6 x SATA 6Gb/s connectors
 1 x CPU fan header
 1 x system fan header
 1 x front panel header
 1 x front panel audio header
 1 x S/PDIF Out header
 1 x speaker header
 2 x USB 3.0/2.0 headers
 2 x USB 2.0/1.1 headers
 2 x serial port headers
 1 x parallel port header
 1 x Clear CMOS jumper
Back Panel
Connectors
 1 x PS/2 keyboard port
 1 x PS/2 mouse port
 1 x D-Sub port
 1 x DVI-D port
 1 x HDMI port
 1 x DisplayPort
 4 x USB 3.0/2.0 ports
 2 x USB 2.0/1.1 ports
 1xRJ-45port
 1 x optical S/PDIF Out connector
 5 xaudiojacks(Center/Subwoofer Speaker Out, Rear Speaker Out, Line In,
Line Out, Mic In)
I/O Controller  iTE
®
I/O Controller Chip
- 7 -