- 89 - Appendix
Figure 4
B. Installing Windows Vista
(The procedure below assumes that only one RAID array exists in your system.)
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps.
When a screen similar to that below appears (RAID hard drive will not be detected at this stage), select Load
Driver (Figure 3).
Figure 3
Step 2:
Insert the motherboard driver disk (Method A) or the oppy disk/USB ash drive that contains the driver (Method
B), then specify the location of the driver (Figure 4). Note: For users using a SATA optical drive, be sure to
copy the driver les from the motherboard driver disk to a USB ash drive before installing Windows Vista (go
to the BootDrv folder and save the whole iRST folder to the USB ash drive). Then use Method B to load the
driver.
Method A:
Insert the motherboard driver disk into your system and browse to the following directory:
\BootDrv\iRST\32Bit
For Windows Vista 64-bit, browse to the 64Bit folder.
Method B:
Insert the USB ash drive containing the driver les and browse to \iRST\32Bit (for Windows Vista 32-bit) or \
iRST\64Bit (for Windows Vista 64-bit).
To Next Page
Loading...
