Gigabyte GA-X58A-UD9 - Page 21

- 21 - Hardware Installation
C. Conguring the Graphics Card Driver
C-1. To Enable CrossFireX Function
C-2. To Enable SLI Function
For 2-Way CrossFireX:
After installing the
graphics card driver in
the operating system, go
to the Catalyst Control
Center. Browse to the
CrossFireX menu and
select the Enable
CrossFireX
™
check box.
Click OK to apply.
For 3-Way CrossFireX:
Browse to the CrossFireX
menu, select the Enable
CrossFireX
™
check box,
and select the 3 GPUs
combination. Click OK to
apply.
Procedure and driver screen for enabling CrossFireX/SLI technology may differ by graphics cards.
Refer to the manual that came with your graphics cards for more information about enabling Cross-
FireX technology.
For 2-Way SLI:
After installing the graph-
ics card driver in the
operating system, go
to the NVIDIA Control
Panel. Browse to the
Set SLI and PhysX con-
figuration screen and
ensure PhysX and SLI
are enabled.
For 4-Way CrossFireX:
Browse to the CrossFireX
menu, select the Enable
CrossFireX
™
check box,
and select the 4 GPUs
combination. Click OK to
apply.
For 3-Way SLI:
Browse to the Set SLI
and PhysX configura-
tion screen and ensure
PhysX and 3-way are
enabled.
For 4-Way SLI:
Browse to the Set SLI
and PhysX configura-
tion screen and ensure
PhysX and Quad SLI are
enabled.