Gigabyte GA-X99-SLI - Page 66

Conguring SATA Hard Drive(s)
- 66 -
Step 2:
IfyouwanttocongureUEFIRAID,followthestepsin"C-1."ToenterthelegacyRAIDROM,savethesettings
and exit BIOS Setup. Refer to "C-2" for more information.
B.ConguringSATAcontrollermodeinBIOSSetup
MakesuretoconguretheSATAcontrollermodecorrectlyinsystemBIOSSetup.
Step 1:
Turnonyourcomputerandpress<Delete>toenterBIOSSetupduringthePOST(Power-OnSelf-Test).Goto
Chipset\PCHSATAConguration, make sure SATA Controller is enabled. To create RAID, set Congure
SATA as to RAID(Figure1).IfyoudonotwanttocreateRAID,setthisitemtoIDE or AHCI.
Figure 1
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.