Gigabyte GA-X99-SLI - Page 68

Conguring SATA Hard Drive(s)
- 68 -
Step 3:
On the Intel(R) Rapid Storage Technology menu, press <Enter> on Create RAID Volume to enter the Create
RAID Volumescreen.Enteravolumenamewith1~16letters(letterscannotbespecialcharacters)underthe
Name item and press <Enter>. Then, select a RAID level(Figure4).RAIDlevelssupportedincludeRAID0,
RAID1,Recovery,RAID10,andRAID5(theselectionsavailabledependonthenumberoftheharddrives
beinginstalled).Next,usethedownarrowkeytomovetoSelect Disks.
Step 4:
Under Select Disks item, select the hard drives to be included in the RAID array. Press the <Space> key
ontheharddrivestobeselected(selectedharddrivesaremarkedwith"X").Thensetthestripeblocksize
(Figure5).Thestripeblocksizecanbesetfrom4KBto128KB.Onceyouhaveselectedthestripeblock
size, set the volume capacity.
Figure 4
Figure 5