Storage Interface (M2_20G and SATA Express connectors can only be used one at a time. The
SATA Express connector becomes unavailable when an M.2 SSD is installed,
but the SATA3 4/5 connectors are still functional.)
- 4 x SATA 6Gb/s connectors (sSATA3 0~3), supporting IDE and AHCI
modes only
(An operating system installed on the SATA3 0~5 ports cannot be used on the
sSATA 0~3 ports.)
USB
Chipset:
- 2 x USB 3.0/2.0 ports available through the internal USB header
- 8 x USB 2.0/1.1 ports (4 ports on the back panel, 4 ports available through
the internal USB headers)
Chipset + Renesas
®
uPD720210 USB 3.0 Hub:
- 4 x USB 3.0/2.0 ports on the back panel
Internal
Connectors
1 x 24-pin ATX main power connector
1 x 8-pin ATX 12V power connector
1 x 4-pin ATX 12V power connector
1 x OC PEG Power Connector
1 x SATA Express connector
10 x SATA 6Gb/s connectors
1 x M.2 Socket 3 connector
1 x CPU fan header
1 x water cooling fan header (CPU_OPT)
3 x system fan headers
1 x Thunderbolt
™
add-in card connector
1 x OC Panel connector (for future expansion)
1 x front panel header
1 x front panel audio header
1 x S/PDIF Out header
1 x USB 3.0/2.0 header
2 x USB 2.0/1.1 headers
1 x serial port header
1 x Clear CMOS jumper
1 x power button
1 x reset button
1 x Clear CMOS button
1 x CPU mode switch
1 x OC Trigger switch
1 x DualBIOS switch
1 x BIOS switch
Voltage Measurement Points
Back Panel
Connectors
1 x PS/2 keyboard port
1 x PS/2 mouse port
4 x USB 2.0/1.1 ports
4 x USB 3.0/2.0 ports
1 x RJ-45 port
1 x optical S/PDIF Out connector
5 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Line In,
Line Out, Mic In)
To Next Page
Loading...
