Gigabyte GA-Z170X-Designare - Page 49

BIOS Setup
- 49 -
& CPU Vcore/CPU VCCSA/CPU VCCIO/DDRVTT Channel A/B Voltage/DRAM Channel A/B
Voltage/DDRVPP Channel A/B Voltage/+3.3V/+5V/PCH Core/+12V/CPU VAXG
Displays the current system voltages.
& CPU/PCH/System Temperature
Displays current CPU/Chipset/System temperature.
& CPU Fan Speed/1st System Fan Speed/3rd System Fan Speed (CPU_FAN, SYS_FAN1,
and SYS_FAN3 Connectors)
Displays current CPU/system fan speeds.
& CPU OPT/Pump Fan Speed/2nd System Fan/Pump Speed (Fan/Pump Speed)
(CPU_OPT_PUMP and SYS_FAN2_PUMP Connectors)
Displays current CPU water cooling/system fan/pump speed.
& CPU/System/PCH Temperature Warning
Sets the warning threshold for CPU/system/Chipset temperature. When temperature exceeds the threshold,
BIOSwill emitwarning sound. Options are: Disabled (default), 60
o
C/140
o
F, 70
o
C/158
o
F, 80
o
C/176
o
F,
90
o
C/194
o
F.
& CPU/CPU OPT/Pump/System Fan/Pump Fail Warning
Allows the system to emit warning sound if the fan/pump is not connected or fails. Check the fan/pump
conditionorfan/pumpconnectionwhenthisoccurs.(Default:Disabled)
& CPU Fan Speed Control (CPU_FAN Connector)
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Normal Allows the fan to run at different speeds according to the CPU temperature. You
can adjust the fan speed with System Information Viewer based on your system
requirements.(Default)
Silent Allows the fan to run at slow speeds.
Manual Allows you to control the fan speed under the Fan Speed Percentage item.
Full Speed Allows the fan to run at full speeds.
& Fan Speed Percentage
 Allowsyoutocontrolthefanspeed.ThisitemiscongurableonlywhenCPU Fan Speed Control is set
to Manual. Options are: 0.75 PWM value /
o
C ~ 2.50 PWM value /
o
C.
& CPU OPT/Pump Fan Control Mode (CPU_OPT_PUMP Connector)
Auto Lets the BIOS automatically detect the type of fan/pump installed and sets the optimal
control mode.
Voltage  Voltagemodeisrecommendedfora3-pinfan/pump.(Default)
PWM PWM mode is recommended for a 4-pin fan/pump.
& CPU OPT/Pump Fan Speed Control (CPU_OPT_PUMP Connector)
Allows you to determine whether to enable the fan/pump speed control function and adjust the fan/pump
speed.
Normal Allows the fan/pump to run at different speeds according to the CPU temperature. You
can adjust the fan/pump speed with System Information Viewer based on your system
requirements.(Default)
Silent Allows the fan/pump to run at slow speeds.
Manual Allows you to control the fan/pump speed under the Fan Speed Percentage item.
Full Speed Allows the fan/pump to run at full speeds.