Gigabyte GA-Z270-Gaming K3 - Page 30

& Storage Boot Option Control
 AllowsyoutoselectwhethertoenabletheUEFIorlegacyoptionROMforthestoragedevicecontroller.
Donotlaunch DisablesoptionROM.
Legacy  EnableslegacyoptionROMonly.(Default)
UEFI   EnablesUEFIoptionROMonly.
 ThisitemiscongurableonlywhenCSM Support is set to Enabled.
& Other PCI devices
 AllowsyoutoselectwhethertoenabletheUEFIorLegacyoptionROMforthePCIdevicecontrollerother
than the LAN, storage device, and graphics controllers.
Donotlaunch DisablesoptionROM.
Legacy  EnableslegacyoptionROMonly.
UEFI   EnablesUEFIoptionROMonly.(Default)
 ThisitemiscongurableonlywhenCSM Support is set to Enabled.
& Administrator Password
 Allowsyoutocongureanadministratorpassword.Press<Enter>onthisitem,typethepassword,and
thenpress<Enter>.Youwillberequestedtoconrmthepassword.Typethepasswordagainandpress
<Enter>.Youmustentertheadministratorpassword(oruserpassword)atsystemstartupandwhenentering
BIOSSetup.Differingfromtheuserpassword,theadministratorpasswordallowsyoutomakechangesto
all BIOS settings.
& User Password
 Allowsyoutocongureauserpassword.Press<Enter>onthisitem,typethepassword,andthenpress
<Enter>.Youwillberequestedtoconrmthepassword.Typethepasswordagainandpress<Enter>.
Youmustentertheadministratorpassword(oruserpassword)atsystemstartupandwhenenteringBIOS
Setup. However, the user password only allows you to make changes to certain BIOS settings but not all.
 Tocancelthepassword,press<Enter>onthepassworditemandwhenrequestedforthepassword,enter
thecorrectonerst.Whenpromptedforanewpassword,press<Enter>withoutenteringanypassword.
Press<Enter>againwhenpromptedtoconrm.
 NOTE:BeforesettingtheUserPassword,besuretosettheAdministratorPasswordrst.
- 30 -