Gigabyte GA-Z270-Gaming K3 - Page 7

USB  Chipset+ASMedia
®
USB 3.1 Gen 2 Controller:
- 1 x USB Type-C
™
port on the back panel, with USB 3.1 Gen 2 support
 - 1xUSB3.1Gen2Type-Aport(red)onthebackpanel
 Chipset:
- 8 x USB 3.1 Gen 1 ports (4 ports on the back panel, 4 ports available through
theinternalUSBheaders)
- 6 x USB 2.0/1.1 ports (2 ports on the back panel, 4 ports available through
theinternalUSBheaders)
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 1 x M.2 Socket 3 connector
 2 x SATA Express connectors
 6 x SATA 6Gb/s connectors
 1 x CPU fan header
 1 x water cooling CPU fan header
 2 x system fan headers
 1 x system fan/water cooling pump header
 1 x front panel header
 1 x front panel audio header
 1xS/PDIFOutheader
 2 x USB 3.1 Gen 1 headers
 2 x USB 2.0/1.1 headers
 1xTrustedPlatformModule(TPM)header
 1 x Thunderbolt
™
add-in card connector
 1 x Clear CMOS jumper
Back Panel
Connectors
 1 x PS/2 keyboard/mouse port
 1xDVI-Dport
 1xHDMIport
 1 x USB Type-C
™
port, with USB 3.1 Gen 2 support
 1xUSB3.1Gen2Type-Aport(red)
 4 x USB 3.1 Gen 1 ports
 2 x USB2.0/1.1 ports
 1xRJ-45port
 6xaudiojacks(Center/SubwooferSpeakerOut,RearSpeakerOut,SideSpeaker
Out,LineIn,LineOut,MicIn)
I/O Controller  iTE
®
I/O Controller Chip
Hardware
Monitor
 Voltage detection
 Temperature detection
 Fan speed detection
 Overheating warning
 Fan fail warning
 Fan speed control
 * Whetherthefan(pump)speedcontrolfunctionissupportedwilldependonthefan
(pump)youinstall.
- 7 -