Gigabyte GA-Z270-HD3P - Page 14

5) CPU/DRAM/VGA/BOOT(StatusLEDs)
The status LEDs show the current state of the CPU, memory, graphics card, and BIOS. If a particular LED
is on, that means the corresponding device is not working normally.
CPU: CPU status LED
DRAM: Memory status LED
VGA: Graphics card status LED
BOOT: BIOS status LED
7) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
®
ChipsetsupportsRAID0,
RAID1,RAID5,andRAID10.RefertoChapter3,"ConguringaRAIDSet,"forinstructionsonconguring
aRAIDarray.
To enable hot-plugging for the SATA ports, refer to Chapter 2,
"BIOS Setup," "Peripherals\SATAAndRST Conguration," for
more information.
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
6) SATAEXPRESS(SATAExpressConnector)
Each SATA Express connector supports a single SATA Express device.
CPU DRAM
VGA BOOT
1 0
7 1
7
1
SATA3
5 3
4 2
SATA3
G.QBOFM
G.QBOFM
- 14 -