Gigabyte GA-Z270M-D3H - Connectivity and Internal Interfaces; System Monitoring and BIOS Overview

USB  Chipset:
- 1 x USB Type-C
™
port on the back panel, with USB 3.1 Gen 1 support
- 8 x USB 3.1 Gen 1 ports (6 ports on the back panel, 2 ports available through
the internal USB headers)
- 4 x USB 2.0/1.1 ports available through the internal USB headers
Internal
Connectors
 1 x 24-pin ATX main power connector
 1x8-pinATX12Vpowerconnector
 1 x M.2 Socket 3 connector
 3 x SATA Express connectors
 6 x SATA 6Gb/s connectors
 1 x CPU fan header
 3 x system fan headers
 1 x front panel header
 1 x front panel audio header
 1 x S/PDIF Out header
 1 x USB 3.1 Gen 1 header
 2 x USB 2.0/1.1 headers
 1 x Trusted Platform Module (TPM) header
 1 x serial port header
 1 x parallel port header
 1 x Clear CMOS jumper
Back Panel
Connectors
 1 x PS/2 keyboard/mouse port
 1 x D-Sub port
 1xDVI-Dport
 1 x HDMI port
 1 x USB Type-C
™
port, with USB 3.1 Gen 1 support
 6 x USB 3.1 Gen 1 ports
 1xRJ-45port
 6xaudiojacks(Center/SubwooferSpeakerOut,RearSpeakerOut,SideSpeaker
Out, Line In, Line Out, Mic In)
I/O Controller  iTE
®
I/O Controller Chip
Hardware
Monitor
 Voltagedetection
 Temperature detection
 Fan speed detection
 Overheating warning
 Fan fail warning
 Fan speed control
* Whether the fan speed control function is supported will depend on the cooler you
install.
BIOS  2x64Mbitash
 Use of licensed AMI UEFI BIOS
 Support for DualBIOS
™
 PnP 1.0a, DMI 2.7, WfM 2.0, SM BIOS 2.7, ACPI 5.0
- 7 -