Gigabyte GA-Z68MX-UD2H-B3 - Page 11

- 11 - Hardware Installation
Storage Interface Chipset: 
- 2 x SATA 6Gb/s connectors (SATA3_0~SATA3_1) supporting up to 2 SATA
6Gb/s devices
- 3 x SATA 3Gb/s connectors (SATA2_2~SATA2_4) supporting up to 3 SATA
3Gb/s devices
- 1 x eSATA 3Gb/s connector on the back panel supporting up to 1 SATA 3Gb/s
device
- Support for SATA RAID 0, RAID 1, RAID 5, and RAID 10
* When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the
system performance of the RAID set may vary depending on the devices being
connected.
Marvell 88SE9172 chip: 
- 2 x SATA 6Gb/s connectors (GSATA3_5, GSATA3_6) supporting up to 2
SATA 6Gb/s devices
- Support for SATA RAID 0 and RAID 1
USB Chipset: 
- Up to 14 USB 2.0/1.1 ports (4 on the back panel, 10 via the USB brackets
connected to the internal USB headers)
2 x Etron EJ168 chips: 
- Up to 4 USB 3.0/2.0 ports (2 on the back panel, 2 via the USB bracket
connected to the internal USB header)
Internal
Connectors
1 x 24-pin ATX main power connector 
1 x 8-pin ATX 12V power connector 
4 x SATA 6Gb/s connectors 
3 x SATA 3Gb/s connectors 
1 x CPU fan header 
1 x system fan header 
1 x front panel header 
1 x front panel audio header 
1 x S/PDIF Out header 
5 x USB 2.0/1.1 headers 
1 x USB 3.0/2.0 header 
1 x serial port header 
1 x clearing CMOS jumper 
1 x Trusted Platform Module (TPM) header 
Back Panel
Connectors
1 x PS/2 keyboard/mouse port 
1 x D-Sub port 
1 x DVI-D port 
1 x optical S/PDIF Out connector 
1 x HDMI port 
1 x DisplayPort 
4 x USB 2.0/1.1 ports 
2 x USB 3.0/2.0 ports 
1 x eSATA 3Gb/s connector 