Gigabyte GA-Z68X-UD3R-B3 - Page 51

- 51 - BIOS Setup
When a Cable Problem Occurs...
 Ifacableproblemoccursonaspeciedpairofwires,theStatuseldwillshowShort and then length
shown will be the approximate distance to the fault or short.
Example:
Part1-2 Status = Short / Length = 2m
Explanation: A fault or short might occur at about 2m on Part 1-2.
Note: Part 4-5 and Part 7-8 are not used in a 10/100 Mbps environment, so their Statuseldswillshow
Open, and the length shown is the approximate length of the attached LAN cable.
Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
R_USB30 Controller (Etron EJ168 USB Controller, USB 3.0/2.0 ports on the back panel)
Enables or disables the back panel Etron EJ168 USB controller. (Default: Enabled)
R_USB30 Turbo (Etron EJ168 USB Controller, USB 3.0/2.0 ports on the back panel)
Enables or disables the Turbo USB mode for the Etron EJ168 USB controller. The actual
performance may vary depending on the number of devices being installed. (Default: Disabled)
F_USB30 Controller (Etron EJ168 USB Controller, USB 3.0/2.0 ports routed to the on-
board F_USB30 header)
Enables or disables the front panel Etron EJ168 USB controller. (Default: Enabled)
GSATA3 Controller (Marvell 88SE9172 Chip, GSATA3_6 and GSATA3_7 connectors)
Enables or disables the SATA controller integrated in the Marvell 88SE9172 chip. (Default: Enabled)
GSATA3 Ctrl Mode (Marvell 88SE9172 Chip, GSATA3_6 and GSATA3_7 connectors)
 EnablesordisablesRAIDfortheSATAcontrollerintegratedintheMarvell88SE9172chiporcongures
the SATA controller to AHCI mode.
IDE  CongurestheSATAcontrollertoIDEmode.(Default)
AHCI  CongurestheSATAcontrollertoAHCImode.AdvancedHostControllerInterface(AHCI)
isaninterfacespecicationthatallowsthestoragedrivertoenableadvancedSerialATA
features such as Native Command Queuing and hot plug.
RAID Enables RAID for the SATA controllers.
Onboard Serial Port 1
 EnablesordisablestheserialportandspeciesitsbaseI/Oaddressandcorrespondinginterrupt.
Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.
Link Detected Displays transmission speed.
Cable Length Displays the approximate length of the attached LAN cable.
Note: The Gigabit hub will only operate at a speed of 10/100 Mbps in MS-DOS mode; it will operate at a
normal speed of 10/100/1000 Mbps in Windows mode or when the LAN Boot ROM is activated.