Gigabyte GA-Z68X-UD4-B3 - 5-1-2 Configuring Marvell 88 SE9172 SATA Controllers

- 89 - Appendix
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Step 2:
Save changes and exit BIOS Setup.
Figure 1
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
Integrated Peripherals
eXtreme Hard Drive (XHD) [Disabled]
PCH SATA Control Mode [IDE]
SATA Port0-3 Native Mode [Enabled]
USB Controllers [Enabled]
USB Legacy Function [Enabled]
USB Storage Function [Enabled]
Azalia Codec [Auto]
Onboard H/W 1394 [Enabled]
Onboard H/W LAN [Enabled]

SMART LAN [Press Enter]
Onboard LAN Boot ROM [Disabled]
R_USB30 Controller [Enabled]
R_USB30 Turbo [Disabled]
F_USB30 Controller [Enabled]
GSATA3 Controller [Enabled]
GSATA3 Ctrl Mode [RAID]
eSATA3 Controller [Enabled]
eSATA3 Ctrl Mode [RAID]
Onboard Serial Port 1 [3F8/IRQ4]
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

5-1-2 Conguring Marvell 88SE9172 SATA Controllers
A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to avail-
able SATA port on the motherboard. One of the Marvell 88SE9172 SATA controllers controls the onboard
GSATA3_6/7 connector and the other controls the eSATA ports on the back panel. Then connect the power
connector from your power supply to the hard drive.
B. Conguring SATA controller and RAID mode in BIOS Setup
MakesuretoconguretheSATAcontrollermodecorrectlyinsystemBIOSSetup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST. In BIOS Setup, go to Inte-
grated Peripherals.ToenableRAID,seethetablebelowforconguringdifferentSATAcontrollersforRAID.
Controller Connectors BIOS Settings
Marvell GSATA3_6/7 Set GSATA3 Controller
to
Enabled
88SE9172 Set GSATA3 Ctrl Mode
to
RAID
Marvell eSATA Set eSATA3 Controller
to
Enabled
88SE9172 Set eSATA3 Ctrl Mode
to
RAID