Appendix - 96 -
Figure 2
B. Installing Windows XP
Before installing Windows XP, connect a USB oppy disk drive to your computer rst because you need to install
the SATA RAID/AHCI driver from a oppy disk that contains the driver during the OS installation. Without the
driver, the hard drive(s) may not be recognized during the Windows setup process. First, copy the driver from
the motherboard driver disk to a oppy disk. Refer to the methods below.
Method A:
For the Intel Z77, copy all les in the • \BootDrv\iRST\32Bit folder to your oppy disk. To install Windows
64-Bit, copy the les in the 64Bit folder.
For the Marvell 88SE9172, • copy all les in the \BootDrv\Marvell\RAID\Floppy32 folder to your oppy disk.
To install Windows 64-Bit, copy the les in the Floppy64 folder.
For AHCI mode, depending on whether you want to install the 32- or 64-bit version, copy the les in the
AHCI\Floppy32 or AHCI\Floppy64 folder.
Method B:
Steps:
Use an alternative system and insert the motherboard driver disk.1:
From your optical drive folder, double click the 2: Menu.exe le in the BootDrv folder. A Command Prompt
window will open similar to that in Figure 2.
nsert the blank formatted disk (if you're using a USB oppy disk drive, make sure it is designated as drive 3:
A). Select the controller driver by pressing the corresponding letter from the menu and press <Enter>. For
example, from the menu in Figure 2,
For the Intel Z77, select • 8) Intel Rapid Storage driver for 32bit system for Windows XP 32-bit operating
system.
For the Marvell 88SE9172, select • 7) Marvell RAID driver. (For AHCI drive(s), select Marvell AHCI
driver.)
Your system will then automatically copy the driver les to the oppy disk. Press any key to exit when nished.
To Next Page
Loading...
