Gigabyte GA-Z77X-UP7 - Internal Graphics; Trusted Computing

- 59 -
BIOS Setup
& Internal Graphics
Enables or disables the onboard graphics function. (Default: Auto)
& Internal Graphics Memory Size
Allows you to set the onboard graphics memory size. Options are: 32M~1024M. (Default: 64M)
& DVMT Total Memory Size
Allows you to allocate the DVMT memory size of the onboard graphics. Options are: 128M, 256M, MAX.
(Default: MAX)
& Init Display First
 SpeciestherstinitiationofthemonitordisplayfromtheinstalledPCIExpressgraphicscardortheonboard
graphics.
IGFX   Setstheonboardgraphicsastherstdisplay.
PCIe1Slot SetsthegraphicscardonthePCIEX16_1slotastherstdisplay.(Default)
PCIe2Slot SetsthegraphicscardonthePCIEX8_1slotastherstdisplay.
PCIe3Slot SetsthegraphicscardonthePCIEX16_3slotastherstdisplay.
PCIe4Slot SetsthegraphicscardonthePCIEX8_2slotastherstdisplay.
& Intel(R) Rapid Start Technology
 EnablesordisablesIntelRapidStartTechnology.ThisitemiscongurableonlywhenanSSDisinstalled.
(Default: Disabled)
& Legacy USB Support
Allows USB keyboard/mouse to be used in MS-DOS. (Default: Enabled)
& XHCI Hand-off
Determines whether to enable XHCI Hand-off feature for an operating system without XHCI Hand-off
support. (Default: Enabled)
& EHCI Hand-off
Determines whether to enable EHCI Hand-off feature for an operating system without EHCI Hand-off
support. (Default: Disabled)
& Port 60/64 Emulation
Enables or disables emulation of I/O ports 64h and 60h. This should be enabled for full legacy support
for USB keyboards/mice in MS-DOS or in operating system that does not natively support USB devices.
(Default: Disabled)
& USB Storage Devices
Displays a list of connected USB mass storage devices. This item appears only when a USB storage device
is installed.
` Trusted Computing
& TPM SUPPORT
Enables or disables Trusted Platform Module (TPM). Set this item to Enable when a TPM device is installed.
(Default: Disable)
& OnBoard USB3.0 Controller#1 (VIA VL800 USB Controller, USB 3.0/2.0 ports on the
back panel)
Enables or disables the VIA VL800 USB controller. (Default: Enabled)