Gigabyte GA-Z87X-UD5 TH - Back Panel Connectors

- 20 -
Hardware Installation
1-7 Back Panel Connectors
PS/2 Keyboard/Mouse Port
Use this port to connect a PS/2 mouse or keyboard.
USB 3.0/2.0 Port
TheUSB3.0portsupportstheUSB3.0specicationandiscompatibletotheUSB2.0/1.1specication.
UsethisportforUSBdevicessuchasaUSBkeyboard/mouse,USBprinter,USBashdriveandetc.
Antenna Connector
Use this connector to connect an antenna.
(Note) Simultaneous output for DVI-I and the MDP2 Thunderbolt port is not supported. If a monitor is con-
nected to the MDP2 Thunderbolt port , the DVI-I port will become unavailable.
Tighten the antenna cables to the antenna connectors and then move
the antenna to a place where the signal is good.
DVI-I Port
(Note)
TheDVI-IportconformstotheDVI-Ispecicationandsupportsamaximumresolutionof1920x1200(the
actualresolutionssupporteddependonthemonitorbeingused).ConnectamonitorthatsupportsDVI-I
connection to this port.
HDMI Port
(Note)
The HDMI port is HDCP compliant and supports Dolby True HD and DTS HD
MasterAudioformats.Italsosupportsupto192KHz/24bit8-channelLPCMaudio
output. You can use this port to connect your HDMI-supported monitor. The maximum supported resolution
is 4096x2160, but the actual resolutions supported are dependent on the monitor being used.
After installing the HDMI device, make sure to set the default sound playback device to HDMI.
(Theitemnamemaydifferdependingonyouroperatingsystem.Thescreenshotbelowisfrom
Windows8.)
In Windows 8, select All apps>Control Panel>Hardware and
Sound>Sound>Playback,setIntel(R)DisplayAudiotothedefault
playback device.