Gigabyte GA-Z87X-UD5H - Page 84

Conguring SATA Hard Drive(s)
- 84 -
For the Marvell
®
88SE9230:
Turn off your computer and replace the failed hard drive with a new one. Please note to perform the rebuild,
you must enter the GSATARAIDConguration menu in BIOS Setup.
Step 1:
Press <Enter> on GSATARAIDCongurationtoaccesstheRAIDcongurationmenu.Movetheselection
bartothearraytoberebuilt(forexample,VD0:New_VD)andpress<Enter>andthenselectRebuild. Press
<Enter> again.
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Topology Information
Help
ID : 0
Name : New_VD
Status : Degrade
Stripe Size : 64K
RAID Mode : RAID1
Size : 465.7GB
BGA Status : N/A
Number of PDs : 1
Numbers : 0
HBA 0 : Marvell 0
Virtual Disks
New_VD
HDD 0: ST95005620AS
Free Physical Disks
HDD 1: WDC WD1001FALS
Rebuilding with selected physical disk on this array.
ENTER: Operation F10: Exit/Save ESC: Return
[Delete]
[Rebuild]
Step 2:
The selection bar will move to the new drive. Press the <Space> key to select it and then press <Enter>. When
promptedtoconrm,press<Y>tobegintherebuildor<N>tocancel.
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Rebuild->Select free disks
Help
Port ID : 1
PD ID : 1
Type : SATA PD
Status : Uncongured
Size : 931.5GB
Feature Support : NCQ 3Gb/s 48bits
Current Speed : 3Gb/s
Model : WDC WD1001FALS-00E3A0
Serial : WD-WCATR0035311
FW version : 05.01D05
HBA 0 : Marvell 0
Virtual Disks
New_VD
HDD 0: ST95005620AS
Free Physical Disks
* HDD 0: WDC WD1001FALS
Use space bar to select the free disks to be used in the array.
ENTER: Operation SPACE: Select F10: Exit/Save ESC: Return
Do you want to rebuild with selected physical disk on this vd?
Yes No
Rebuild