Gigabyte GA-Z87X-UD5H - Page 85

- 85 -
Conguring SATA Hard Drive(s)
Step 3:
The BGA Rebuild item in the Information block will display the current rebuild progress. After the rebuild is
complete, the Status will display as Functional. Please note the rebuild will be stopped if you exit the RAID
BIOS screen before the rebuild is complete.
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Topology Information
Help
ID : 0
Name : New_VD
Status : Rebuilding
Stripe Size : 64K
RAID Mode : RAID1
Size : 465.7GB
BGA Status : Running
BGA Rebuild : 20%
Number of PDs : 2
Numbers : 0 1
HBA 0 : Marvell 0
Virtual Disks
New_VD
HDD 0:ST95005620AS
HDD 1: WDC WD1001FA
Free Physical Disks
Virtual Disk: A set of disk blocks presented to an operating environment as
a range of consecutively numbered logical blocks with disk-like storage.
ENTER: Operation F10: Exit/Save ESC: Return
Resume the Stopped Rebuild Process
To resume the stopped rebuild process, enter the GSATARAIDConguration menu in BIOS Setup again.
Movetheselectionbartothearraytoberebuilt(forexample,VD0:New_VD).Press<Enter>onthisarrayand
select BGA Resume. Press <Enter> again to continue the rebuild process.
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Topology Information
Help
ID : 0
Name : New_VD
Status : Rebuilding
Stripe Size : 64K
RAID Mode : RAID1
Size : 465.7GB
BGA Status : Paused
BGA Rebuild : 20%
Number of PDs : 2
Numbers : 0 1
HBA 0 : Marvell 0
Virtual Disks
New_VD
HDD 0:ST95005620AS
HDD 1: WDC WD1001FA
Free Physical Disks
Resume BGA on this virtual disk
ENTER: Operation F10: Exit/Save ESC: Return
[Delete]
[BGA Resume]