Gigabyte H261-H60 - Page 13

- 13 - Hardware Installation
Socket
Socket
Security
Security Serve r
Operating Properties
Power S upply
LAN Per node:
 1 x Dedicated management port
Total:
 4 x Dedicated management ports
 1 x 10/100/1000 *CMC global management port
*CMC: Chassis Management Controller, to monitor all status of computing nodes
* Please contact FAE if NCSI function of OCP mezzanine card is needed
Socket
Socket
Security
Security Serve r
Operating Properties
Power S upply
Video  Integrated in Aspeed® AST2500
 2D Video Graphic Adapter with PCIe bus interface
 1920x1200@60Hz 32bpp, DDR4 SDRAM
 Management chip in CMC board:
 Integrated in Aspeed® AST1250
 Integrated in Aspeed® AST2520A2-GP
Socket
Socket
Security
Security Serve r
Operating Properties
Power S upply
Storage Per node:
 3 x 3.5" SATA/SAS hot-swappable HDD/SSD bays
 Onboard SATA DOM support (PIN_7, PIN_8 or external cable)
Total:
 12 x 3.5" SATA/SAS hot-swappable HDD/SSD bays
 2.5" HDD/SSD supported
 SAS card is required for SAS devices support
Socket
Socket
Security
Security Serve r
Operating Properties
Power S upply
RAID  Intel® SATA RAID 0/1/5
Socket
Socket
Security
Security Serve r
Operating Properties
Power S upply
Expansion Slot Per node:
 1 x Half-length low-prole slot with PCIe x16 (Gen3 x16 bus)
 1 x Half-length low-prole slot with PCIe x8 (Gen3 x8 bus)
 1 x OCP mezzanine slot with PCIe Gen3 x16 bus
Total:
 4 x Half-length low-prole slot with PCIe x16 (Gen3 x16 bus)
 4 x Half-length low-prole slot with PCIe x8 (Gen3 x8 bus)
 4 x OCP mezzanine slot with PCIe Gen3 x16 bus
Socket
Socket
Security
Security Serve r
Operating Properties
Power S upply
Internal I/O Per node:
 1 x COM header
 1 x COM header
 1 x TPM header
 1 x BMC SGPIO header
 1 x JTAG BMC header
 1 x PLD header
 1 x Clear CMOS jumper
 1 x IPMB connector
 1 x Buzzer