Gigabyte H261-Z60 - Page 13

- 13 - Hardware Installation
Expansion Slots Per node:
 2 x Half-length low-prole slots with PCIe x16 (Gen3 x16 bus) from CPU_0
 1 x OCP mezzanine slot with PCIe Gen3 x16 bus from CPU_0
 2 x M.2 slots from CPU_0 and CPU_1:
- M-key
- PCIe Gen3 x4
- Supports NGFF-2242/2260/2280/22110 cards
- CPU TDP is limited to 120W if using M.2 device
Total:
 8 x Half-length low-prole slots with PCIe x16 (Gen3 x16 bus) from CPU_0
 4 x OCP mezzanine slots with PCIe Gen3 x16 bus from CPU_0
 8 x M.2 slots from CPU_0 and CPU_1:
- M-key
- PCIe Gen3 x4
- Supports NGFF-2242/2260/2280/22110 cards
- CPU TDP is limited to 120W if using M.2 device
Video  Integrated in Aspeed® AST2500
 2D Video Graphic Adapter with PCIe bus interface
 1920x1200@60Hz 32bpp, DDR4 SDRAM
 Management chip in CMC board:
 Integrated in Aspeed® AST2520A2-GP
Storage
(H261-Z60)
Per node:
 6 x 2.5" SATA hot-swappable HDD/SSD onboard SATA ports
or
 4 x 2.5" SATA /SAS hot-swappable HDD/SSD with SAS RAID Card
Total:
 24 x 2.5" hot-swappable HDD/SSD bays
 SAS card is required for SAS devices support
(H261-Z61) Per node:
 2 x 2.5" U.2, 4 x SATA/SAS hot-swappable HDD/SSD bays
Total:
 8 x 2.5" U.2, 16 x SATA/SAS hot-swappable HDD/SSD bays
 SAS card is required for SAS devices support
Internal IO Per Node:
 2 x M.2 slots
 1 x COM header
 1 x TPM header
 1 x BMC SGPIO header
 1 x JTAG BMC header
 1 x PLD header
 1 x Clear CMOS jumper
 1 x IPMB connector