Gigabyte H261-Z60 - Installing the OCP Card

- 41 - System Hardware Installation
3-9 Installing the OCP Card
• Voltages can be present within the server whenever an AC power source is connected.
This voltage is present even when the main power switch is in the off position. Ensure
that the system is powered-down and all power sources have been disconnected from the
server prior to installing a OCP card.
Failure to observe these warnings could result in personal injury or damage to equipment.
Follow these instructions to install the OCP card:
1. Install the OCP card bracket.
2. Secure the OCP card bracket with a screw.
3. Align the OCP card to the connector on the system board and push in the direction of the arrow
until the OCP card sits rmly in the system.
4. Secure the OCP card with three screws.
4
4
4
2
1
3
• Before installing the OCP card the left PCI-E riser assembly must be rst removed, see
the 「Installing the PCI Expansion Card「 section for instructions on removing the PCI-E
riser assembly.