Gigabyte H370N WIFI - Storage, USB, and Audio Headers

5) LED_C (RGB (RGBW) LED Strip Header)
The header can be used to connect a standard 5050 RGB (RGBW) LED strip (12V/G/R/B/W), with maximum
power rating of 2A (12V) and maximum length of 2m.
Pin No. Denition
1 12V
2 G
3 R
4 B
5 W
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
For how to turn on/off the lights of the LED strip, refer to the instructions on in Chapter 2, "BIOS
Setup," "Peripherals."
6) D_LED (Digital LED Strip Header)
The header can be used to connect a standard 5050 digital LED strip, with maximum power rating of 2A
(12V or 5V) and maximum length of 5m or maximum number of 300 LEDs.
Pin No. Denition
1 V
2 D
3 G
Connect your digital LED strip to the header. There are 12V and 5V digital LED strips. Be sure to verify the
voltage requirements of your digital LED strip and set the DLED_V_SW jumper accordingly. The power pin
(marked with a triangle on the plug) of the LED strip must be connected to Pin 1 of the digital LED strip
header. Incorrect connection may lead to the damage of the LED strip.
Digital LED Strip
1
1
7) DLED_V_SW (Digital LED Strip Power Select Jumper)
The jumper allows you to select the supply voltage of the D_LED header. Be sure to verify the voltage
requirements of your digital LED strip and set the correct voltage with this jumper before connection.
Incorrect connection may lead to the damage of the LED strip.
1
1
1-2: 5V
2-3: 12V
Connect your RGB (RGBW) LED strip to the header. The power pin (marked with a triangle on the plug) of
the LED strip must be connected to Pin 1 (12V) of the LED strip header. Incorrect connection may lead to
the damage of the LED strip.
RGBW
LED Strip
1
12V
RGB
LED Strip
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
For how to turn on/off the lights of the LED strip, refer to the instructions on in Chapter 2, "BIOS
Setup," "Peripherals."
F_USB30
F_U B_ 
F_  F_ 
 _ B
BS_ B
SB_ B
_S  S_ _ B _U _ B
 
 
S  
 
123
 
123
 
123
 
123
1
1
1
1
BSS
S
_S 
SSU
 
1 2 3  
 S3
BSSS

U
 __ 3
F_USB3F
S  _ S  _
S  _
SF
 
B_
B_
F _0
S S
_0F
_F
_
_
__B
 
U
S  _S
_
SF_
USB0_B
B_
F_USB3

F_USB303

_

_3U
1
- 15 -