Gigabyte H470M K - Page 18

- 18 -
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
To enable hot-plugging for the SATA ports, please navigate to the "BIOS Setup" page of GIGABYTE's
website and search for "Settings\IO Ports\SATA And RST Conguration" for more information.
6) SATA3 0/1 (SATA 6Gb/s Connectors) j
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device.
SATA3
1
0
7
1
DEBUG PORT
G.QBOFM
DEBUG PORT
G.QBOFM
7) M2A_SB (M.2 Socket 3 Connector) j
The M.2 connector supports M.2 PCIe SSDs.
Follow the steps below to correctly install an M.2 SSD in the M.2
connector.
Step 1:
Pull the clip's tab up and out of the mounting hole. Slide the M.2
SSD into the connector at an angle.
Step 2:
Press the M.2 SSD down and then secure it by pressing the clip's
tab into the mounting hole.
j Only for H510M K.