Gigabyte Q370M D3H GSM PLUS - Page 23

& System Memory Multiplier
Allows you to set the system memory multiplier. Auto sets memory multiplier according to memory SPD
data.(Default:Auto)
& Memory Ref Clock
 Allowsyoutomanuallyadjustthememoryreferenceclock.(Default:Auto)
& Memory Odd Ratio (100/133 or 200/266)
EnabledallowsQclktoruninoddfrequency.(Default:Auto)
& Memory Frequency (MHz)
 Therstmemoryfrequencyvalueisthenormaloperatingfrequencyofthememorybeingused;thesecond
is the memory frequency that is automatically adjusted according to the System Memory Multiplier settings.
` PC Health Status
& Reset Case Open Status
Disabled  Keepsorclearstherecordofpreviouschassisintrusionstatus.(Default)
Enabled Clears the record of previous chassis intrusion status and the Case Openeldwill
show"No"atnextboot.
& Case Open
Displays the detection status of the chassis intrusion detection device attached to the motherboard CI
header.Ifthesystemchassiscoverisremoved,thiseldwillshow"Yes",otherwiseitwillshow"No".To
clear the chassis intrusion status record, set Reset Case Open Status to Enabled, save the settings to
the CMOS, and then restart your system.
& CPU Vcore/CPU VCCSA/DRAM Channel A/B Voltage/+3.3V/+5V/+12V/CPU VAXG
Displays the current system voltages.
& CPU/System/PCH/VRM MOS Temperature
Displays current CPU/System/Chipset temperature.
& CPU/System Fan Speed
Displays current CPU/system fan speeds.
& CPU/System/PCH/VRM MOS Temperature Warning
 SetsthewarningthresholdforCPU/system/Chipsettemperature.Whentemperatureexceedsthethreshold,
BIOSwill emitwarning sound. Options are: Disabled(default), 60
o
C/140
o
F, 70
o
C/158
o
F, 80
o
C/176
o
F,
90
o
C/194
o
F.
& CPU/System Fan Fail Warning
Allows the system to emit warning sound if the fan is not connected or fails. Check the fan condition or fan
connectionwhenthisoccurs.(Default:Disabled)
& CPU/System Fan Control Mode
Auto Lets the BIOS automatically detect the type of fan installed and sets the optimal control
mode.(Default)
Voltage  Voltagemodeisrecommendedfora3-pinfan.
PWM   PWMmodeisrecommendedfora4-pinfan.
& CPU Fan Speed Control
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Normal  Allowsthefan to runat different speeds accordingto the CPUtemperature.You
canadjust the fanspeed with SystemInformation Viewerbased on yoursystem
requirements.(Default)
Silent Allows the fan to run at slow speeds.
Manual Allows you to control the fan speed under the Fan Speed Percentage item.
Full Speed Allows the fan to run at full speeds.
- 23 -