Gigabyte R162-Z10 - Page 11

- 11 - Hardware Installation
Video  Integrated in Aspeed® AST2500
 2D Video Graphic Adapter with PCIe bus interface
 1920x1200@60Hz 32bpp
Storage
(R162-Z10)
 10 x 2.5" U.2 hot-swappable SSD bays
- 6 x 2.5" NVMe/SATA/SAS hybrid ports
- 4 x 2.5" SATA/SAS ports
(R162-Z11)  6 x 2.5" SATA/SAS hot-swappable HDD/SSD bays
 4 x 2.5" NVMe hot-swappable SSD bays
* SAS card is required for SAS devices support
* Backplane JP_SEL switch set from "00010" to "00000" (all OFF) if SAS RAID crad
is installed
SAS N/A
Internal I/O  3 x M.2 slots
 1 x USB 3.0 header
 1 x TPM header
 1 x OCP 2.0 mezzanine slots
 1 x Front panel header
 1 x Back plane board header
 1 x IPMB connector
 1 x Clear CMOS jumper
 1 x BIOS recovery jumper
Front I/O  1 x USB 3.0
 1 x Power button with LED
 1 x ID button with LED
 1 x NMI button
 1 x Reset button
 2 x LAN activity LEDs
 1 x HDD activity LED
 1 x System status LED
Rear I/O  2 x USB 3.0
 1 x VGA
 2 x RJ45
 1 x MLAN
 1 x ID LED
Backplane I/O  Backplane P/N: 9CBP10A1NR-00
 Speed and bandwidth:
 10 x ports for PCIe x4
TPM  1 x TPM header with LPC interface
 Optional TPM2.0 kit: CTM000