Gigabyte R282-N80 - Page 11

- 11 - Hardware Installation
Storage  Front side: 16 x 2.5" SATA/SAS ports, 8 x 2.5" SATA/SAS/Gen4 NVMe hybrid ports
 Rear side: 2 x 2.5" SATA/SAS hot-swappable HDD/SSD bays ( Connected via
SAS Expander)
 SAS card is required for SAS devices support
 Broadcom SAS35x36R expander
 Bandwidth: SATA 6Gb/s or SAS 12Gb/s per port
 Default conguration supports:
 8 x 2.5" NVMe drives, non-supported SATA/SAS drives without SAS card
 Suggested 12Gb/s SAS cards: CRA4448
SAS  Supported via add-on SAS Card
Internal
Connectors
 2 x CPU fan headers
 1 x USB 3.0 header
 1 x TPM header
 1 x VROC connector
 1 x Front panel header
 1 x HDD back plane board header
 1 x IPMB connector
 1 x Clear CMOS jumper
 1 x BIOS recovery jumper
Front Panel
LED/Buttons
 2 x USB 3.0
 1 x Power button with LED
 1 x ID button with LED
 1 x Reset button
 1 x NMI button
 1 x System status LED
 1 x HDD activity LED
 2 x LAN activity LEDs
Rear Panel I/O  2 x USB 3.0
 1 x VGA
 1 x COM (RJ45 type)
 2 x RJ45
 1 x MLAN
 1 x ID button with LED
Backplane I/O  2 x USB 3.0
 1 x VGA
 1 x COM (RJ45 type)
 2 x RJ45
 1 x MLAN
 1 x ID button with LED
TPM  1 x TPM header with SPI interface
 Optional TPM2.0 kit: CTM010