Gigabyte Ultra Durable 3 - Page 27

6} F_PANEL (Front Panel Header)
Connect
the
power
switch,
reset
switch,
and
system
status
indicator
on
the
chassis
to
this
header
ac-
cording
to
the
pin
assignments
below.
Note
the
positive
and
negative
pins
before
connecting
the
cables.
Rosai] [Hard Orive]
[Swich | fActivty LED.
paga Minap
MSG (Message/Sleep LED, Yellow):
System
Status
|
LED
—
|
Connects
to
the
power
status
indicator
on
the
chassis
front
panel.
The
LED
so
On
[is
on
when
the
System
is
operating.
The
LED
keeps
blinking
when
the
sys-
|
St
Blinking
|
tem
is
in
S1
sleep
state.
The
LED
is
off
when
the
system
is
in
$3/S4
sleep
S3/S4/S5
o
state
or
powered
off (S5).
PW
(Power
Swilch,
Red):
Connects
to
the
power
switch
on
the
chassis
front
panel.
You
may
configure
the
way
to
turn
off
your
system
using
the
power
switch
(refer
to
Chapter
2,
"BIOS
Setup,"
"Power
Management
Setup,"
for
more
Information).
*
HD
(Hard
Drive
Activity
LED,
Blue)
Connects
to
the
hard
drive
activity
LED
on
the
chassis
front
panel.
The
LED
Is
on
when
the
hard
drive
is
reading
or writing
data.
*
RES
(Reset
Swilch,
Green):
Connects
to
the
reset
switch
on
the
chassis
front
panel.
Press
the
reset
switch
to
restart
the
computer
if
the
computer
freezes
and
fails
to perform
a
normal
restart.
*
NC
(Purple):
No
connection.
The
front
panel
design
may
differ
by
chassis.
A
front
panel
module
mainly
consists
of
power
Bono
reset
switch,
hard
drive
activity
LED
and
etc.
When
connecting
your
chassis
front
panel
module
to
this
header,
make
sure
the
wire
assignments
and
the
pin
assignments
are
matched
correctly.
-25-
Hardware
Installation