Gigabyte W480M VISION W - Page 28

` Advanced Memory Settings
& Extreme Memory Prole (X.M.P.)
(Note)
, System Memory Multiplier, Memory Ref Clock,
Memory Odd Ratio (100/133 or 200/266), Memory Frequency(MHz)
The settings above are synchronous to those under the same items on the Advanced Frequency
Settings menu.
& Memory Boot Mode
(Note)
Provides memory detection and training methods.
Auto    LetstheBIOSautomaticallycongurethissetting.(Default)
Normal The BIOS automatically performs memory training. Please note that if the system
becomes unstable or unbootable, try to clear the CMOS values and reset the
boardtodefaultvalues.(Refertotheintroductionsofthebattery/clearCMOS
jumper in Chapter 1 for how to clear the CMOS values.)
Enable Fast Boot Skipmemorydetectionandtraininginsomespeciccriteriaforfastermemoryboot.
Disable Fast Boot Detect and train memory at every single boot.
& Realtime Memory Timing
 Allowsyoutone-tunememorytimingsaftertheBIOSstage.(Default:Auto)
& Memory Enhancement Settings
 Provides severalmemory performance enhancement settings: Auto, Relax OC, EnhancedStability,
Normal(basicperformance),EnhancedPerformance,HighFrequency,HighDensity,andDDR-4500+.
(Default: Auto)
& Memory Channel Detection Message
Allows you to determine whether to show an alert message when the memory is not installed in the
optimal memory channel. (Default: Enabled)
& ProleDDRVoltage
When using a non-XMP memory module or ExtremeMemoryProle(X.M.P.) is set to Disabled, the
valueisdisplayedaccordingtoyourmemoryspecication.WhenExtremeMemoryProle(X.M.P.) is
set to Prole1 or Prole2, the value is displayed according to the SPD data on the XMP memory.
& Memory Multiplier Tweaker
Provides different levels of memory auto-tuning. (Default: Auto)
& Channel Interleaving
Enables or disables memory channel interleaving. Enabled allows the system to simultaneously access
different channels of the memory to increase memory performance and stability. Auto lets the BIOS
automaticallycongurethissetting.(Default:Auto)
& Rank Interleaving
Enables or disables memory rank interleaving. Enabled allows the system to simultaneously access
different ranks of the memory to increase memory performance and stability. Auto lets the BIOS
automaticallycongurethissetting.(Default:Auto)
` Memory Channels Timings
d Channels Standard Timing Control, Channels Advanced Timing Control, Channels
Misc Timing Control
These sections provide memory timing settings. Note: Your system may become unstable or fail to boot
after you make changes on the memory timings. If this occurs, please reset the board to default values
by loading optimized defaults or clearing the CMOS values.
(Note) This item is present only when you install a CPU and a memory module that support this feature.
- 28 -