Gigabyte X299 AORUS Gaming - Page 17

10) LED_C1/LED_C2 (RGB (RGBW) LED Strip Extension Cable Headers)
The headers can be used to connect a standard 5050 RGB (RGBW) LED strip (12V/G/R/B/W), with maximum
power rating of 2A (12V) and maximum length of 2m.
Pin No. Denition
1 12V
2 G
3 R
4 B
5 W
1
1
LED_C1
LED_C2
Connect one end of the RGB (RGBW) LED strip extension cable to the
header and the other end to your RGB (RGBW) LED strip. The black
wire (marked with a triangle on the plug) of the extension cable must
be connected to Pin 1 (12V) of this header. The 12V pin (marked with
an arrow) on the other end of the extension cable must be lined up with
the 12V of the LED strip. Be careful with the connection orientation of
the LED strip; incorrect connection may lead to the damage of the LED
strip. If you are connecting a RGBW LED strip (5-pin), combine the
twoplugsoftheextensioncabletogetherrst.Ifyouareconnectinga
RGB LED strip (4-pin), use only the 4-pin plug of the extension cable.
12V
1
RGBW
LED
Strip
RGB
LED
Strip
11) D_LED (Digital LED Strip Header)
The header can be used to connect a standard 5050 digital LED strip, with maximum power rating of 2A
(12V or 5V) and maximum length of 5m or maximum number of 300 LEDs.
Pin No. Denition
1 V
2 D
3 G
1
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
Connect your digital LED strip to the header. There are 12V and 5V
digital LED strips. Be sure to verify the voltage requirements of your
digital LED strip and set the DLED_V_SW jumper accordingly. The
power pin (marked with a triangle on the plug) of the LED strip must be
connected to Pin 1 of the digital LED strip header. Incorrect connection
may lead to the damage of the LED strip.
Digital LED Strip
1
For how to turn on/off the lights of the LED strip, refer to the instructions on in Chapter 2, "BIOS
Setup," "Peripherals."
- 17 -