Gigabyte X299X AORUS XTREME WF - Page 70

Conguring a RAID Set
- 70 -
Step 4:
Under Select Disks item, select the hard drives to be included in the RAID array. Press the <Space> key on
the hard drives to be selected (selected hard drives are marked with "X"). Then set the stripe block size (Figure
5). The stripe block size can be set from 4 KB to 128 KB. Once you have selected the stripe block size, set
the volume capacity.
Figure 5
Step 5:
After setting the capacity, move to Create Volume and press <Enter> to begin. (Figure 6)
Figure 6