Gigabyte X399 AORUS Gaming 7 - Page 28

- 28 -
Hardware Installation
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power cord
from the power outlet to prevent damage to the devices.
For how to turn on/off the lights of the LED strip, refer to the instructions on in Chapter 2, "BIOS Setup,"
"Peripherals," or Chapter 5, "Unique Features," "APP Center\RGB Fusion."
Connect your digital LED strip to the header. There are 12V and 5V digital LED
strips. Be sure to verify the voltage requirements of your digital LED strip and
set the DLED_V_SW jumper accordingly. The power pin (marked with a triangle
on the plug) of the LED strip must be connected to Pin 1 of the digital LED strip
header. Incorrect connection may lead to the damage of the LED strip.
8) D_LED(DigitalLEDStripHeader)
The header can be used to connect a standard 5050 digital LED strip, with maximum power rating of 2A
(12V or 5V) and maximum length of 5m or maximum number of 300 LEDs.
Pin No. Denition
1 V
2 D
3 G
1
Digital LED Strip
1
9) DLED_V_SW(DigitalLEDStripPowerSelectJumper)
This jumper allows you to select the supply voltage of the D_LED header. Be sure to verify the voltage
requirements of your digital LED strip and set the correct voltage with this jumper before connection.
Incorrect connection may lead to the damage of the LED strip.
1
1
1-2: 5V
2-3: 12V