Step 3:
On the RAIDXpert2 Conguration Utility screen, press <Enter> on Array Management to enter the Create
Array screen. Then, select a RAID level (Figure 4). RAID levels supported include RAID 0, RAID 1, and RAID
10 (the selections available depend on the number of the hard drives being installed). Next, press <Enter> on
Select Physical Disks to enter the Select Physical Disks screen.
Step 4:
On the Select Physical Disks screen, select the hard drives to be included in the RAID array and set them to
Enabled. Next, use the down arrow key to move to Apply Changes and press <Enter> (Figure 5).Then return
to the previous screen and set the Array Size, Array Size Unit, Read Cache Policy and Write Cache Policy.
Figure 4
Figure 5
To Next Page
Loading...
