Gigabyte X570S UD - Smart Fan 6

Usethe<F6>functionkeytoquicklyswitchtothisscreen.Thisscreenallowsyoutocongurefanspeedrelated
settings for each fan header or monitor your system/CPU temperature.
& TUNE ALL
Allows you to apply the current settings to all fan headers.
& Temperature
Displays the current temperature of the selected target area.
& Fan Speed
Displays current fan/pump speeds.
& Flow Rate
 Displaystheowrateofyourwatercoolingsystem.Press<Enter>onFan Speed to switch to this function.
& FAN Speed Control
 Allowsyoutodeterminewhethertoenablethefanspeedcontrolfunctionandadjustthefanspeed.
Normal  Allowsthefantorunatdifferentspeedsaccordingtothetemperature.Youcanadjust
the fan speed with System Information Viewer based on your system requirements.
(Default)
Silent Allows the fan to run at slow speeds.
Manual  Allowsyoutodragthecurvenodestoadjustfanspeed.OryoucanusetheEZ Tuning
feature.Afteradjustingthenodeposition,pressApply to automatically calculate the
slope of the curve.
Full Speed Allows the fan to run at full speeds.
& Fan Control Use Temperature Input
Allows you to select the reference temperature for fan speed control.
& Temperature Interval
Allows you to select the temperature interval for fan speed change.
& FAN/PUMP Control Mode
Auto Lets the BIOS automatically detect the type of fan installed and sets the optimal control
mode. (Default)
Voltage Voltage mode is recommended for a 3-pin fan/pump.
PWM PWM mode is recommended for a 4-pin fan/pump.
& FAN/PUMP Stop
Enables or disables the fan/pump stop function. You can set the temperature limit using the temperature
curve. The fan or pump stops operation when the temperature is lower than the limit. (Default: Disabled)
2-3 Smart Fan 6
- 24 -
25 / 45 24 / 43 25 / 45 24 / 43 25 / 45