Gigabyte X570S UD - Page 28

& SVM Mode
 VirtualizationenhancedbyVirtualizationTechnologywillallowaplatformtorunmultipleoperatingsystems
andapplicationsinindependentpartitions.Withvirtualization,onecomputersystemcanfunctionasmultiple
virtual systems. (Default: Disabled)
& AMD Cool&Quiet function
Enabled   LetstheAMDCool'n'QuietdriverdynamicallyadjusttheCPUclockandVIDto
reduce heat output from your computer and its power consumption. (Default)
Disabled Disables this function.
& PPC Adjustment
(Note 1)
 AllowsyoutoxthePStateoftheCPU.(Default:PState0)
& Global C-state Control
(Note 1)
Allows you to determine whether to let the CPU enter C states. When enabled, the CPU core frequency
will be reduced during system halt state to decrease power consumption. (Default: Auto)
& Power Supply Idle Control
(Note 1)
Enables or disables Package C6 State.
Typical Current Idle Disables this function.
Low Current Idle Enables this function.
Auto    LetstheBIOSautomaticallycongurethissetting.(Default)
& CCD Control
(Note 1)
Sets the number of CCDs to be used. (Default: Auto)
& Downcore Control
Allows you to select the number of CPU cores to enable (the number of CPU cores may vary by CPU).
(Default: Auto)
& SMT Mode
Allows you to enable or disable the CPU Simultaneous Multi-Threading technology. (Default: Auto)
& CPPC
(Note 1)
Enables or disables the CPPC feature. (Default: Auto)
& CPPC Preferred Cores
(Note 1)
Enables or disables the CPPC Preferred Cores feature. (Default: Auto)
& ExtremeMemoryProle(X.M.P.)
(Note 2)
Allows the BIOS to read the SPD data on XMP memory module(s) to enhance memory performance when
enabled.
Disabled Disables this function. (Default)
Prole1   UsesProle1settings.
Prole2
(Note2)
  UsesProle2settings.
& XMP High Frequency Support
(Note 2)
 Allowsyoutoselectthecompatibilitylevelforhigh-frequencymemory.Thisitemiscongurableonlywhen
ExtremeMemoryProle(X.M.P.) is set to Prole1 or Prole2. (Default: Auto)
& System Memory Multiplier
Allows you to set the system memory multiplier. Auto sets memory multiplier according to memory SPD
data. (Default: Auto)
& FCLK Frequency
(Note 2)
 AllowsyoutosettheFCLKfrequency.Optionsare:Auto(default),667MHz~4000MHz.
& UCLK Mode
(Note 2)
Allows you to specify the UCLK mode. (Default: Auto)
(Note1) ThisitemispresentonlywhenyouinstallaCPUthatsupportsthisfeature.
(Note2) ThisitemispresentonlywhenyouinstallaCPUandamemorymodulethatsupportthisfeature.
- 27 -
28 / 45 27 / 43 28 / 45 27 / 43 28 / 45