Gigabyte X570S UD - Page 29

 Advanced Memory Settings
 Memory Subtimings
d Standard Timing Control, Advanced Timing Control, CAD Bus Setup Timing, CAD Bus
DriveStrength,DataBusConguration
 Thesesectionsprovidememorytimingsettings.Note:Yoursystemmaybecomeunstableorfailtoboot
after you make changes on the memory timings. If this occurs, please reset the board to default values by
loadingoptimizeddefaultsorclearingtheCMOSvalues.
 SPD Info
Displays information on the installed memory.
& Power Down Enable
Enables or disables Power Down support. (Default: Auto)
& CPU Vcore/Dynamic Vcore(DVID)/VCORE SOC/Dynamic VCORE SOC(DVID)/CPU VDD18/
CPU VDDP/DRAM Voltage (CH A/B)/DDRVPP Voltage (CH A/B)/DRAM Termination (CH
A/B)/VDDP Voltage Control
(Note)
/VDDG Voltage Control
(Note)
 TheseitemsallowyoutoadjusttheCPUVcoreandmemoryvoltages.
 CPU/VRM Settings
 ThissubmenuallowsyoutocongureLoad-LineCalibrationlevel.
(Note) ThisitemispresentonlywhenyouinstallaCPUthatsupportsthisfeature.
- 28 -
29 / 45 28 / 43 29 / 45 28 / 43 29 / 45