Gigabyte X670E AORUS PRO X - Page 25

- 25 -
& Please visit GIGABYTE's website for details on using M.2 EZ-Latch Click/M.2 EZ-Latch Plus.
M.2 SSD installation with M.2 EZ-Latch Click: https://www.gigabyte.com/WebPage/1048/M.2-EZ-Latch-Click.html
M.2 SSD installation with M.2 EZ-Latch Plus: https://www.gigabyte.com/WebPage/920/M2-latchplus.html
M.2 SSD removal with M.2 EZ-Latch Plus: https://www.gigabyte.com/WebPage/921/removeM2.html
* Motherboard heatsink design may vary by model.
M2B_CPU/M2D_SB:
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
Step 1:
Turn the M.2 EZ-Latch Click clip clockwise and remove the motherboard heatsink. Locate the proper
mounting hole for the M.2 SSD to be installed and secure the M.2 EZ-Latch Plus clip in the hole rst.
Step 2:
Insert the M.2 SSD into the M.2 connector at an angle. Press down on the front end of the M.2 SSD and
make sure the M.2 SSD is secured by the clip.
Step 3:
Remove the protective lm from the bottom of the motherboard heatsink, and nally, turn the M.2 EZ-Latch
Click clip clockwise and then install the heatsink back in place.
M2A_CPU/M2C_SB:
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
Step 1:
Turn the M.2 EZ-Latch Click clip clockwise and remove the motherboard heatsink. .
Step 2:
Remove the protective lm from the thermal pad (only the M2A_CPU connector has the thermal pad) on
the M.2 connector. Insert the M.2 SSD into the M.2 connector at an angle.
Step 3:
Press down on the front end of the M.2 SSD and make sure the M.2 SSD is secured by the clip. Remove
the protective lm from the bottom of the motherboard heatsink, and nally, turn the M.2 EZ-Latch Click
clip clockwise and then install the heatsink back in place.
If you want install an M.2 SSD in the 110mm hole, remove the EZ-Latch Plus clip from the 80mm
hole rst.